Search found 6 matches

by vazkus
Sat Jun 16, 2018 12:56 am
Forum: Stepper Motors and Controls
Topic: AR-series: home/LS sensors with 48v power supply
Replies: 5
Views: 193

Re: AR-series: home/LS sensors with 48v power supply

Good that you asked this question :)

I checked wiring again and found that it was wrong. IN-COM2 was hooked up to GND, while for NPN sensor type it has to be connected too VCC.

Thanks again.
by vazkus
Tue Jun 12, 2018 10:57 pm
Forum: Stepper Motors and Controls
Topic: AR-series: home/LS sensors with 48v power supply
Replies: 5
Views: 193

Re: AR-series: home/LS sensors with 48v power supply

Dear om_tech_support_KR. I have a follow-up question regarding homing sensor. I'm trying to use Bernstein KIB-M12NS inductive sensor for HOMES (here's the spec: https://www.bernstein.eu/fileadmin/downloads/datenblaetter/6502303006%20xx.pdf), its NPN type sensor and I think I have the wiring set up c...
by vazkus
Wed May 16, 2018 4:02 pm
Forum: Stepper Motors and Controls
Topic: ARD-KD: resetting overvoltage alarm through rs-485/modbus-rtu
Replies: 3
Views: 154

Re: ARD-KD: resetting overvoltage alarm through rs-485/modbus-rtu

wow! thank you for taking time and writing such a complete response! In my implementation I'm using register 0181h to reset the alarm. I actually noticed that it works the first time alarm is triggered, but does nothing to subsequent alarms. Now I know I need to write 0 first clear the alarm reset i...
by vazkus
Mon May 14, 2018 3:39 pm
Forum: Stepper Motors and Controls
Topic: ARD-KD: resetting overvoltage alarm through rs-485/modbus-rtu
Replies: 3
Views: 154

ARD-KD: resetting overvoltage alarm through rs-485/modbus-rtu

Hi, Sometimes when setting overly high speed or/and low acceleration I get the 'overvoltage' alarm/warning. I understand what that means, I show proper warning message to the user with recomendation to reduce the speed and increase the acceleration. The problem is I am unable to reset this alarm thr...
by vazkus
Mon May 14, 2018 2:29 pm
Forum: Stepper Motors and Controls
Topic: AR-series: home/LS sensors with 48v power supply
Replies: 5
Views: 193

Re: AR-series: home/LS sensors with 48v power supply

Thank you very much for your quick and prompt response!
by vazkus
Fri May 11, 2018 3:17 pm
Forum: Stepper Motors and Controls
Topic: AR-series: home/LS sensors with 48v power supply
Replies: 5
Views: 193

AR-series: home/LS sensors with 48v power supply

Hi, I have a setup with a ARD-KD driver that runs on 48v power supply. I need to connect 1+ inductive sensors (like Bernstein KIB-M12) for home/limit switching. What is the right way of connecting these sensors? Does the driver provide 24v (or anything <36v) that I can use as a VCC for the sensor? T...

Go to advanced search