Hollow shaft gearhead shaft mounting
Q: I am interested in your hollow shaft gearhead design for brushless DC motors. I am working on an application where I would like to mount the shaft onto your gearhead so that the shaft comes out the same side as the motor is mounted. I noticed that in your manual, you only listed mounting instructions for one direction, where load shaft comes out the opposite side of the motor. Can I mount it so that it comes out the same side as the motor?
A: In regards to your question, our brushless DC motors with hollow shaft gearhead can have the external output shaft mounted in either direction. The dimensional drawing for hollow shaft gearhead shows a cross section view of the bore (please use the link below to download dimensional drawing for 104mm frame size)
http://catalog.orientalmotor.com/browse ... etid=53755
Please note the dimensional drawing for the bore shows exactly the same dimension and structure on each end, where a ball bearing provides support on each side. Therefore, the overhung load and thrust load are the same as well regardless the mounting orientation. In addition, 2 tab holes for mounting protective back covers are available on both sides.
Please feel free to contact Oriental Motor Technical Support if there are any additional questions.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest