Q: I keep getting a motor sensor error alarms when I turn on power to my driver. What's wrong?
-this applies to all brushless DC motor & driver systems as well as closed-loop step motor & driver systems.
-the following answer also applies for encoder failure alarms.
A: A motor sensor error alarm, or a encoder failure alarm, occurs when:
1. The motor is not connected. Connect the motor with its dedicated cable.
2. Improper signal cable connection or wire breakage. This typically happens when the cable is made by a third party. Check the cable for breakage or improper connection.
3. These alarms will occur when a cable is extended too long by a third party, and the sensor or encoder signal drops too low for our drivers to recognize. You can try using a bigger gauge wire, or boost the signal somehow.
Please be aware that if a third party cable is used with our products, the standard 2-year warranty is voided. If you absolutely need to make your own cable, please test and verify connections thoroughly.
A question of interest from our Technical Support group will be posted here each day.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest