ASX Software: NO/NC Indicators, Check Marks

User avatar
om_tech_support_JT
Posts: 1057
Joined: Fri Mar 12, 2010 2:59 pm
Location: Torrance, CA
Contact:

ASX Software: NO/NC Indicators, Check Marks

Postby om_tech_support_JT » Wed May 18, 2011 4:39 pm

Q: I do not completely understand your NO/NC indicators by your Input/Output Assignments section within your SYSTEM CONFIG window (in your ASX Immediate Motion Creator GUI software). What does it mean when checked? What does it mean when not checked?

A: NO = Normally open, and NC = normally closed. You can use these settings to select your preferred circuit logic; either normally open or normally closed. A check mark by an input or output means that it is normally open.

Return to “Stepping Motors & Controls”

Who is online

Users browsing this forum: No registered users and 3 guests