LABVIEW: Carriage Return

User avatar
Posts: 1057
Joined: Fri Mar 12, 2010 2:59 pm
Location: Torrance, CA

LABVIEW: Carriage Return

Postby om_tech_support_JT » Wed Jun 15, 2011 7:09 pm

Q: What are the character designations for "carriage return" for LABVIEW? I'm using LABVIEW's VISA function to send ASCII commands to one of your step motor controllers/pulse generators.

A: It's "/R/N", which basically means "carriage return then a new line". You would always need a carriage return after every line of command you send to our controller, or else our controllers won't take it.

Return to “Stepping Motors & Controls”

Who is online

Users browsing this forum: No registered users and 3 guests