AS Series Built-in Controller RS-232C Communication

User avatar
om_tech_support_JT
Posts: 1057
Joined: Fri Mar 12, 2010 2:59 pm
Location: Torrance, CA
Contact:

AS Series Built-in Controller RS-232C Communication

Postby om_tech_support_JT » Thu Jun 06, 2013 4:24 pm

Q: I am trying to connect the ASD24B-AP driver with built-in controller unit to my computer using the RS232 cable and a RS232 to USB adapter. My computer recognizes the adapter. However, I cannot communicate with the controller through HyperTerminal. The controller is not recognized.

A: The ASD24B-AP driver with built-in controller unit will also require a 24VDC voltage in order to provide power for RS232 data communication as well as the ASG, BSG output. Therefore, besides the main 110-115VAC power supply, you will also need to connect 24VDC voltage to PIN 1 and GND to PIN 2 on the CN4 connector to establish connection between your PC and controller. Please follow the link below to download the AS series built-in controller manual from our website. Please refer to Pg. 27-28 for CN4 Terminal connection signal table.

http://www.orientalmotor.com/products/pdfs/opmanuals/HM-40023-2E.pdf

Return to “Stepping Motors & Controls”

Who is online

Users browsing this forum: No registered users and 2 guests