Q: I’m using the BX series and thinking of upgrading to the newer BXII series for more driver functionality. Is the OPX-2A data setter required to change the parameters like how the OPX-1A was necessary for the BX series?
A: No, the BX II series does not require the OPX-2A hand held data setter to change the stored data or driver parameters anymore. You can simply use the digital display and buttons which are located on the front of the BX II series drivers. To change the parameters on the BXII series you use ID’s and change its set values. To view the full parameter ID list reference page 89 in the manual linked below:
http://orientalmotor.com/products/pdfs/ ... 142-3E.pdf
This is what the Operation data ID looks like for the speed control mode operation data.
This is what the Operation data ID looks like for the position control mode operation data.
Here's how would you access the ID parameter in parameter mode.
You can also use the MEXE02 data edit GUI software to change the stored data and driver parameters. This is a FREE download from our website. You can download it using the link below. NOTE: to connect to the software our CC05IF-USB communication cable is required.
http://www.orientalmotor.com/support/so ... tware.html
If you have further questions, please contact our technical support group or post your question here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest