Unclearable Emergency Stop Error

User avatar
Posts: 1057
Joined: Fri Mar 12, 2010 2:59 pm
Location: Torrance, CA

Unclearable Emergency Stop Error

Postby om_tech_support_JT » Thu Feb 16, 2012 6:09 pm

Q: I'm using a EZS II series motorized slide systems with your EZED2 software. I can't seem to clear this alarm which is referred to as an "emergency stop error #68". Can you help?

A: Please turn off the power, turn your PENDANT switch off on your controller, then turn on power again. The error should go away. The PENDANT switch should only be on when there's an EZT1 teach pendant connected instead of the EZED2 software. Both can be used to set parameters and program motion profiles.

Return to “Linear & Rotary Actuators and Controls”

Who is online

Users browsing this forum: No registered users and 3 guests