Q: I'm using a EZS II series motorized slide systems with your EZED2 software. I can't seem to clear this alarm which is referred to as an "emergency stop error #68". Can you help?
A: Please turn off the power, turn your PENDANT switch off on your controller, then turn on power again. The error should go away. The PENDANT switch should only be on when there's an EZT1 teach pendant connected instead of the EZED2 software. Both can be used to set parameters and program motion profiles.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests