Wiring scx11 to nxd20-c

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
dennychris123
Posts: 1
Joined: Fri Oct 26, 2018 11:56 pm

Wiring scx11 to nxd20-c

Postby dennychris123 » Sat Oct 27, 2018 12:15 am

Hey everybody
I confuse to wiring scx11 to nxd20-c
Refer to startup manual of scx11 page 5
It says scx11 must set the switch setting to 5v
But in my case i want to control via plc to i/o port off scx11 ,and my plc logic voltage is 24 volt
Please help me
Thanks

om_tech_support_KR
Posts: 13
Joined: Thu Jan 11, 2018 3:03 pm

Re: Wiring scx11 to nxd20-c

Postby om_tech_support_KR » Mon Oct 29, 2018 8:51 am

Hi Denny,

The 5/24 VDC and Sink/Source switches are for the settings of the driver being used with the SCX11 controller. Those switches are for the Driver connector on the SCX11 they don't affect the I/O connector. For your PLC when wiring to the I/O connector on the SCX11 you can use 5-24 VDC reference the link below for connection example.

https://www.orientalmotor.com/products/ ... df#page=32


Return to “Stepper Motors and Controls”

Who is online

Users browsing this forum: No registered users and 5 guests