RKII Series Clarification

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
Mr.Thota
Posts: 2
Joined: Tue Oct 02, 2018 9:45 pm

RKII Series Clarification

Postby Mr.Thota » Fri Dec 07, 2018 6:42 am

Hi !!

We are planning to use RKII Series (RKS569) with encoder.
so please let us know the response time of encoder ??

thanks & regards,

om_tech_support_KR
Posts: 15
Joined: Thu Jan 11, 2018 3:03 pm

Re: RKII Series Clarification

Postby om_tech_support_KR » Fri Dec 07, 2018 1:48 pm

Hi Mr.Thota,

Could you explain what you mean by response time of encoder? The RK2 series offers an encoder motor but its only compatible with the built in controller drivers so they connect directly to the driver not to a controller. You can read the feedback from the command position and the encoder feedback from the registers using RS485 communication to compare them or you can look at them from the MEXE02 software. You can also set up a warning or alarm if the degrees between these reach a certain point reference the link below for those parameters. This does not have an auto correct feature like our AR and AZ closed loop packages.

https://www.orientalmotor.com/products/ ... df#page=75


Return to “Stepper Motors and Controls”

Who is online

Users browsing this forum: No registered users and 2 guests